Jump to content

Recommend upgrade for surround speaker for Marantz SR5013 Amp


Recommended Posts

Hi

 

As before. Was looking to get the Denon X2500 amp. But at the end gotten the Marantz SR5013 as it have better spec and cheaper than the Denon.

 

Ok. Current my speaker setup is

2 x front Pioneer S-HF10 speaker. Its a 200w 6ohm speaker.

centre and 2 rear surround is an old Infinity minuette sat speaker. spec as:

SPECIFICATION S SATELLITE S

Frequency Response 200Hz- 20kHz

Crossover Frequency 5kHz

Sensitivity 87dB @ 1 watt, 1 meter

Nominal Impedance compatible with 8 ohms

Power Rating Use with amplifiers rated between 15 and 80 watts RMS

Drivers 3 Vz" shilded woofer and W polycarbonate tweeter with acoustic lens

 

SPECIFICATION S CENTER

Frequency Response 150Hz-20kHz

Crossover Frequency 5kHz

Sensitivity 87dB @ 1 watt,

1 meter

Nominal Impedance compatible with 8 ohms

Power Rating Use with amplifiers rated between 15 and 80 watts RMS

Drivers 3V2"shilded woofer (2 pes) and W polycarbonate tweeter with acoustic lens in D'Appolito configuration

 

infinity_minuette.jpg

 

Looking to check the rear surround and centre speaker. Any intro?

 

Was thinking to get the cheap Onkyo SKH-410 Dolby atmos enable speaker to place on top on my old Pioneer S-HF10 for Dolby atmos effect as have the extra 2 speaker channel to use.

 

Any expert?

 

Thank you.

Link to post
Share on other sites
×
×
  • Create New...